dd wrt v24 sp2 to use the 5 ghz repeater

Dd wrt v24 sp2 to use the 5 ghz repeater password#

Now, onto the last step for this page.

So, under the Assign to Bridge section, click Add, and select br1 as the bridge, and wl0.1 as the interface. Because the guest WLAN is a Virtual AP, it is named wl0.1.

Next, we must add out guest WLAN to this bridge.

Enter the desired IP address range for the new guest network.

After it refreshes, you will notice two boxes, for Network Address and Subnet Mask.

The rest of the settings are fine as they are.

Give the new bridge a name, such as br1.

In Setup -> Networking, we will be doing a number of things to separate the guest WLAN from the private one.

Dd wrt v24 sp2 to use the 5 ghz repeater password#

It is best to create a password that you share, so that your users’ data is secure. Īlthough traditionally guest networks have no password, this means that all traffic on the guest network is unencrypted, and easily captured. In Wireless -> Wireless Security, type in the password(s) you would like for the private and guest networks. The only limitation is that they must be broadcast on the same channel, if you only have one wireless radio. Multiple SSIDs can be broadcast from the same AP. Enter the name for your guest SSID, and click again. Next, click Add, at the bottom, to add a Virtual Access Point (VAP). In Wireless -> Basic Settings, enter the desired name and channel for your private SSID. Now, begin by preparing your wireless networks. Since this is a fresh installation, you will need to set your administration username and password.

Prepare the routerĬonnect your computer directly to the router. It may help you, but continue Googling, and I am certain you will find the guide you need. If you are seeking to add a guest network to your existing router, or if you are looking for a dedicated guest AP, this is not the solution. This article describes the process for integrating private + guest WiFi Access Points into an existing private network. I encourage you to consult the DD-WRT Wiki to identify compatible devices and their installation procedures. The installation of DD-WRT is beyond the scope of this article. This task requires you to have a fresh, default installation of DD-WRT on any compatible router. Share only the Internet connection from the private network to the Guest_WiFi.Bridge Private_WiFi to the private network.There is already a wireless home router installed, sharing Internet access with the private network. Guest WLAN: 192.168.10.x (separate DHCP server, isolated from Private LAN) Private LAN: 192.168.1.x (DHCP already provided for private addresses, Internet source) The following is a description of the desired network.

So, after some trial, error, and research, I managed to get it to work. Of course, all this needs to be done without impacting the desired service: Internet access.Īlthough I found many guides online for setting up a guest network when the access point was also the primary router, I didn’t find any that worked for the intended network. Secure the access point itself from tampering or unauthorized access.Prevent network abuse (such as P2P file sharing).Disallow access to any computers on the private network.There are many privacy concerns when having guests share your network. Recently I was asked to configure a WiFi access point for a small business, who needed to have both a private internal network, and a public guest network. Creating a Private + Guest WiFi Access Point (DD-WRT)